Effect of Heat Input and Shielding Gas on the Performance of 316 Stainless Steel Gas Tungsten Arc Welding

Document Type : Original Article

Authors

1 Mechanical Department (Production), Faculty of Industrial Education, Suez Univeristy, Suez, Egypt

2 Mechanical Dept., Fac. of Industrial Education, Suez Uni., Egypt

3 Suez University

4 Suez university

Abstract

The effect of nitrogen addition and heat input on weld metal microstructure and mechanical properties of alloy 316 is studied. Autogenous gas tungsten arc welding (GTAW) is employed by adding up to 2 vol‌.% N2 in Ar. Welding speed and heat input rate are measured as functions of gas composition. Weld defects are examined by radiographic testing, and weld metal microstructure is studied by optical microscopy. Mechanical properties of welds are determined by uniaxial testing, hardness measurements, and bending test. Weld dendritic structure is refined by increasing N2 content in Ar. The mechanical properties and cooling rate are lower with increasing heat input. Besides, adding nitrogen to argon shielding gas leads to higher values of the ultimate tensile strength and hardness. The tensile strength, yield stress and elongation percent of welds depends strongly on the heat input and nitrogen content of shielding gas. This is discussed on the basis of microstructural characterization. Moreover, the weld nugget area, cooling time and solidification time increase with increasing heat input and nitrogen content. Finally, after applying the bending test up to 180o no cracks, tearing or surface defects could be observed on welded samples.

Keywords

Main Subjects

Files

Share

How to cite

Statistics